Harbor North
400 Huron St. P.O. Box 504
Huron, Ohio, US, 44839
Schock 35 - main image

1988 Schock 35

location icon Huron, Ohio
Year 1988
Length 35 ft

Fast racer/cruiser! Ready to go sailing


Year Built 1988
Category Sail
Construction Fiberglass
Keel Fin Keel

100% Hand lay-up fiberglass with balsa sandwich
 Flush through-hull fittings
 90-degree turn shut off valves
 High gloss gel coat
 Fiberglass-bonded hull pan
 Glass biaxial unidirectional
 Glass roving
 Hull and deck joint bonded with 3M-5200 and bolted on 4” centers

KEEL 4500 lbs cast lead
  8 ss keel bolts
  Stainless steel rudder stock
  Fiberglass rudder blade with high density foam core

  Tiller extension
  Varnished oak and mahogany laminated tiller
  Glass biaxial and unidirectional glass roving
  Rudder bearings


  100% hand lay-up fiberglass
  Glass used as biaxial andunidirectional glass roving
  Balsa sandwich and marine plywood sandwich in load bearing areas
  Aluminum toe rails bolted on 4”center
  Molded hiking ramps
  Non-skid on deck, cabin top, cockpit sole and seat top
  Two Harken #48.3A 3 speed 2 gear genoa sheet winches
  Two Harken #32.2 STA halyard winches
  Two Harken one speed grip winch handles
  Two double Spinlock halyard stoppers
  All deck blocks are lead aft to the cockpit
  Two Harken adjustable under load genoa car and track systems
  Harken roller bearing traveler with control lines
  Double lifelines and stanchions
  Welded stainless steel bow and stern pulpits
  Four mooring cleats
  Six tinted plexiglass cabin windows


  4-inch pilot berth and seat berth cushions
  Settee berth backrest cushion with pigeon hole storage behind
  Sit down navigation station with storage for charts and shelf for instruments
  Oiled teak bulkhead and cabinets


GALLEY   Large ice box with a pump

  25 gallon water tank

  Stainless steel sink with foot pump

  Plastic laminate galley counter top

  Hideaway stove top cover

  Large condiment storage with shelf and tinted acrylic sliding cabinet doors



  Marine head with holding tank

  Mirrored sliding doors and vanity

  Hanging locker



  17 gallon fuel tank with deck fill

  25 gallon water tank with deck fill pump plate

  9 gallon holding tank with deck pump plate



  Yanmar 3GM30F

  3 cylinder in-line marine diesel

  Fresh water cooled

  Cast brass propeller strut


  1 inch ss propeller shaft

  Raw water filter on engine intake

  Fuel and water separator

  Cockpit engine instrument panel with tachometer, key start and alarms for oil pressure, water temperature and electronics

  Martec folding propeller



  Two 12-volt 90 amp hour batteries

  Circuit breakers on the electrical panel with battery switch and battery condition meter

  Running lights

  Bow lights

  Cabin lights

  Chart table light

  Manual bilge pump



  Port and starboard spinnaker halyards

  Spinnaker pole topping lift

  Spinnaker track on mast

  2-part spinnaker pole butt lift system

  2 spinnaker sheet blocks

  1 spinnaker pole

  1 spinnaker pole foreguy

  1 spinnaker pole foreguy block

  2 spinnaker sheet cleats

  2 spinnaker sheets  


  Keel stepped mast

  Sliding adjustable mast step

  White epoxy painted aluminum mast and boom

  Tri-sec tapered mast section

  Four airfoil painted aluminum tapered spreaders

  All rod standing rigging

  All internal halyards

  One main halyard

  One genoa halyard

  2 spinnaker halyards

  All halyards made of composite material

  Hall Spar quick-vang

      Combination outhaul and flattening reef - internal

  Two interior reefs with lock-off at the gooseneck

  Color-coded lines

  Running checkstays

  Tube inside mast for mast cables

  Fine tune mainsheet system and Barney post

      Cunningham system:  3 part self-cleating at base of mast



Hull                  White

Deck                Light Grey

Waterline            Red




Deluxe interior package:                                


      Teak battens on hull sides

      New interior cushions

      Head vanity with sink and mirror

      Varnished teak and holly cabin sole

Removable, hinged v-berth with 4-inch cushions

CNG stove/oven

Remote hydraulic backstay adjuster

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.